Product ref.: SY-207.033
Manufacturer: P&W accessories
HIGHSIDER CAN-BUS resistor CBW1 (207-033)
(Attention, the actual product may be different from the photo.)HIGHSIDER CAN-BUS resistor CBW1 with DIP switches.
Our newly developed HIGHSIDER CAN-BUS resistor CBW1 is suitable for most vehicles equipped with a CAN-BUS system.
The resistor CBW1 provides a required electrical load for your vehicle, which, if the DIP switches are set correctly, does not lead to an error message in the cockpit with accessory turn signals.
In addition, reliability is ensured. This means: If the accessory indicators fail due to an electronic defect, an error message is immediately displayed in the cockpit.
Up to 2 channels can be operated, such as rear left indicators and rear right indicators. If 2 pairs of indicators (VL,VR,HL,HR) are to be replaced, 2 x CBW1 are required.
What requirements must be met for the use of the CBW1 on the vehicle: Either: LED indicators were installed on the vehicle in their original condition. Or: The vehicle has a CAN-BUS system.
If none of the requirements are met, the CBW1 cannot be installed (!).), then we recommend the following resistors for the vehicle: For flashers with 21 Watt 6.8 Ohm article number 207-025 or 10 Ohm article number 207-028
For flashers with 10 Watt 27 Ohm article number 207-020
The following resistance values can be set:
Measurements:
Connections:
Supplied: 1 piece
Notes:
Paaschburg & Wunderlich is a German giant with tens of thousands of high quality motorcycle accessories. Bike Design has selected the best of the best.
All products from P&W accessories